Juniper Ex Series Deafult Mac Age Out Timer

Configure the timeout interval for entries in the mac table.

This is an expected behavior in junos/qfx (details in below pr).

Webdec 28, 2009 · this article explains the default behavior of ex switches when using 802. 1x mac based authentication.

Links to the docs:.

Webyou can configure the mac table aging time, the maximum time that an entry can remain in the mac table before it “ages out,” on all bridge domains, one or all vpls instances, or.

It also explains the relation between 802. 1x based mac.

Webthe default mac aging time on juniper ex series switches is typically 300 seconds, or 5 minutes.

Websep 23, 2011 · default mac aging time 300sec.

This timer controls how long a mac address remains in the mac address table.

Webis there a logic behind those defaults or am i right to assume that mac table timers should /always/ be higher than arp table timers?

Juniper EX Series Switches with Green IT Consulting

Websep 23, 2011 · default mac aging time 300sec.

This timer controls how long a mac address remains in the mac address table.

Webis there a logic behind those defaults or am i right to assume that mac table timers should /always/ be higher than arp table timers?

Webif your switch runs juniper networks junos operating system (junos os) for ex series switches with support for the enhanced layer 2 software (els) configuration style, you.